Grace-digital SOLO GDI-IRA500 Bedienungsanleitung PDF herunterladen (Seite 2)

QUICKSTART GUIDE - 1

time set up

• What you need before you can use your Internet Radio:

• A broadband internet connection.

• A wireless (Wi-Fi) modem or router connected to your broadband (cable or DSL) internet.

• If your wireless (Wi-Fi) network is password protected, please obtain your password before

proceeding to Step 1. All passwords are UPPER and lower case sensitive.

• A pair of powered wireless speakers or a stereo receiver and speakers.

Step 1: Connect the supplied RCA cable to the RCA connections in the back of the

Solo Wi-Fi Radio Receiver. The other side of the cables should be connected to

available RCA input jacks on the back of your stereo receiver (or powered speakers).

Power your stereo receiver on and choose the input on the front panel of your stereo

receiver that corresponds to the name of the RCA connection on the back of your

receiver.

Set the volume of your stereo or powered speakers to a normal listening level.

Step 2: Plug the round jack of the power cord into the back of the radio and the other

end into an available wall outlet. Within 4 seconds the display will turn on and flash a

series of messages. The messages that are briefly displayed will be ‘Grace Digital

Radio’, ‘Starting…’ then ‘Scanning’.

NOTE: If your radio does not automatically start scanning when plugged into power the

time, please press the power button to turn your radio on to view the main Internet

radio menu. Scroll the large dial to the left or right until the word ‘settings’ is in brackets

{}. Press the large dial inwards to select ‘settings’. On the top of the next screen please

select ‘Network Configurations’ by pressing the large dial inwards. (To go back to

previous menus at any time press the dedicated ‘back’ button on the radio). On the top

of the next screen please select ‘Scan for Networks’ by pressing the large dial inwards.

Step 3: The radio is now scanning for available Wi-Fi (wireless) network(s) in your area.

After the scanning process is complete, the radio will display the names (SSID) of one

or more wireless networks within range. Please scroll the large ‘Select / Menu’ dial to

the left or right until the name of your network is between the brackets {}, for example

{your wireless network}. Now push the large Select dial inwards to select your network.

NOTE: If your radio does not display the name of your wireless network please make

sure that your router is transmitting in 802.11b/g mode. Additionally, please make sure

you are within range of your wireless network.

Step 4: The display will now prompt you to enter in your network’s key. This ‘Key’ is the

same key (password) you use to connect a wireless device (laptop, mobile phone, game

console etc) to your Wi-Fi (wireless) network. This key or password is also sometimes

1 2 3 4 5 6 7 ... 50 51

Keine Kommentare

Grace-digital SOLO GDI-IRA500 Bedienungsanleitung Seite 2